Toilet troubleshooting is one of the most common plumbing repair problems. If your toilet won’t flush at all, you may be overlooking an easy solution that only requires a quick fix. Here are some common reasons why a toilet might not flush:
Clogs
A clog in the toilet drain is the most likely cause for a toilet that won’t flush. Toilets can become clogged with waste, paper products, or toys that have been flushed down the drain. If you suspect a clog, try using a plunger to dislodge the obstruction.
If the plunger doesn’t work, you may need to remove the toilet tank lid and use a pliers or a similar tool to remove the clog from the tank.
Leaky Flapper
If your toilet flushes but quickly stops flushing, it may be due to a leaky flapper. This is a relatively easy fix that requires you to reseat the flapper and/or replace it if necessary. To reseat the flapper, simply follow these steps:
- Turn off the water supply valve by turning the handle clockwise until it stops.
- Flush the toilet to empty the tank.
- Disconnect the chain from the flush handle arm.
- Remove the flapper from the flush valve opening by depressing the retaining tabs and pulling it up and out.
- Clean any sediment or debris from the flush valve seat with a brush or rag.
- Reinstall the flapper by lining up the tabs on the bottom of the flapper with the slots in the flush valve opening.
- Connect the chain to the flush handle arm, and turn on your water supply again.
If these steps don’t solve your toilet troubleshooting problem, you may need to replace your flapper entirely.
Low Water Level
If your toilet won’t flush and you don’t see any obstructions in the drain or tank, it may be because your water level is too low. To fix this issue, simply adjust the float setting on your toilet so that there is enough water in the tank to create a proper flush. Many modern toilets have an adjustment dial or lever on the tank to make this adjustment. If you can’t locate your water level adjustment, you may need to call a professional plumber for assistance.
how to stop your toilet from running
If your toilet is running constantly, it’s not only wasting water, it’s also driving up your water bill. Fortunately, there are a few things you can do to fix the problem.
First, check to see if the flapper needs to be replaced. The flapper is the rubber seal that sits on top of the drain inside the tank. If it is worn or broken, water can run right down the drain instead of being held in the tank until you flush.
You can also check to see if your fill valve needs to be replaced. The fill valve sits at the base of the tank and controls how much water enters the tank when you flush. If your fill valve is malfunctioning, it could be allowing too much water to enter the tank, which can cause your toilet to run.
Finally, check to see if you need a new flush valve. The flush valve sits on top of the toilet bowl and controls how quickly the water drains out of your toilet after each flush. If your flush valve is leaking, it could be causing your toilet to run constantly.
If you’re not sure how to replace any of these parts, you can always call a plumber for help. In most cases, however, replacing the flapper or flush valve is a simple matter that anyone can do. Simply follow the instructions that come with the new parts, and your toilet should be running smoothly in no time. You can also contact Prime Dumpster porta potty rentals if you need to rent a temporary toilet for your home.
Tags
mexicobased 20m series startupsann azevedotechcrunch
council clearview aihatmakertechcrunch
six meps european uslomastechcrunch
About Author
